Back to Album

Next photo

Previous photo


Measuring the chassis twist

The test required six measuring points equally distributed along the chassis, including one at both the front axle and rear axle.  Steel tubes were positioned on both sides of the car, one metre from the centreline.  Measurements were taken before and after the chassis had load applied and the engineer used this data to determine the result.  I was very pleased that it easily passed the legal requirement.

[Locost  Home] [Locost Finished] [Magazine Article] [Background] [Donor Car] [Specifications] [Chassis build] [Photo album] [Donor car] [MX5 parts] [Assembling] [Chassis build] [Front end] [Rear end] [Engine] [Electrics] [Bits & pieces] [Bodywork] [Body finishing] [Interior] [Rotisserie] [Bright 2006] [Clubman cars] [Locost links] [Meet the owner]